Replace the Equipment Asset Tracker battery pack

This document applies only to the two asset tracking devices designed by Verizon Connect. It does not apply to third-party asset tracking devices.

The Equipment Asset Tracker (EAT) device relies on the equipment asset to which it is installed as its primary power source. It includes an internal, non-rechargeable battery pack as its secondary/backup power source.

The Equipment Asset Tracker - Battery (EAT-B) device uses an internal, non-rechargeable battery pack as its only power source.

The battery packs for both devices are replaceable. The battery packs are not interchangeable, that is, you must use the battery pack specific to each device.

Device

Battery Description

Part Number (MMID)

Equipment Asset Tracker (EAT)

Shrink-wrapped pack of 3 L91 batteries; Total capacity approximately 9000 mA 

1100000713

Equipment Asset Tracker - Battery (EAT-B)

Shrink-wrapped pack of 6 L91 batteries; Total capacity approximately 18,000 mA 

1100000712

 Battery_Pack.png

Tools needed to replace the battery pack

  • 5/16” hex head driver to remove the device from mounting on the equipment
  • 2mm hex head driver or allen key to remove the device’s back panel

Replacing the battery pack 

  1. Remove the device from its mounting on the equipment.
  2. Remove the device back cover.

    back_cover.png

  3. Unplug the battery lead and remove the old battery pack. (Wait 20 seconds before plugging a battery pack back in. This allows the device's circuit board to clear.)
  4. Place the new battery pack in the device, taking care not to crimp the battery lead wires, and plug in the battery lead.
  5. With the battery pack lead plugged back in, the device should wake and the LEDs should light up. If not, press the device status button to wake the device. The battery LED should indicate that the device is powered on and flash 4 times to indicate the battery level is at full capacity.
  6. Re-attach the device’s back cover with screws.
  7. Remount the device on the equipment.

Replacing the Device Back Cover (if needed)

If needed, the device back panel can also be ordered to replace a damaged or lost back panel.

As with the battery packs, the back panels for the EAT device and the EAT-B device are different parts and are not interchangeable.

Device

Part Description and Part Number

Part Number (MMID)

Equipment Asset Tracker (EAT)

Replacement Back Cover  920-500146-001

1100000722

Equipment Asset Tracker - Battery (EAT-B)

Replacement Back Cover 

920-500162-001

1100000760

FCC compliance statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.
  • Increase the separation between equipment and receiver.
  • Connect the equipment into an outlet on a circuit different from that to which the
  • receiver is connected. 

Consult the dealer or install technician for help.


Was this article helpful?


1 out of 1 found this helpful