Sensor report

This report allows you to review a vehicle's sensor activity over a specified period of time. You can review on and off activity for sensors and ignitions, and the locations of the activities. Sensors are on-board equipment such as Lifts, PTOs, and Trailer Door Sensors, that are installed on vehicles.

To run this report, see Run a report.

 

Report options

Select which sensors to include, and choose to view when sensors are "Switched On and Off", "Switched On Only", or "Switched Off Only". Sensors are on-board equipment such as Lifts, PTOs, and Trailer Door Sensors, that are installed on vehicles.

 

Advanced options

  • Show exceptions using: To highlight events that exceed your benchmark parameters, select the checkbox and choose a filter from the list. Exceptions show events, such as excessive stops, late starts, or early finishes.
  • Show: Select from "Address Only", "Geofences", or "Both geofences and addresses" to determine whether to show the addresses of places, or geofences that you have created, or both.
  • Include closest x Geofences: Select the number of nearby geofences to display, from 1 to 5.
  • Include page break between drivers: Select this option to display each driver on a separate page. This separation can make it easier to carry out administrative tasks on the report.
  • Days to include: Choose which days to include in the report.
  • Time Zone: Whether to base the time zone in the report on User, Vehicle, or UTC.
  • Include time range: Select the time range to include in the report.
  • Region: Select your country.

Was this article helpful?


0 out of 2 found this helpful